Subaru B9 TRIBECA WX 2007 Manual page 540

asieps_tobira.book 7 ページ ２０１２年２月１０日 金曜日 午後３時２６分
5. Subaru Select Monitor
A: OPERATION
1. HOW TO USE SUBARU SELECT MONI-
TOR
1) Prepare the Subaru Select Monitor kit.
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Connect the Subaru Select Monitor to data link
connector.
(1) Data link connector is located in the lower
portion of the instrument panel (on the driver's
side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
Do not connect the scan tools except for Suba-
ru Select Monitor.
4) Turn the ignition switch to ON (engine OFF), and
run the Subaru Select Monitor.
5) Using the Subaru Select Monitor, call up DTC
and various data, then record them.
2. READ DIAGNOSTIC TROUBLE CODE
(DTC) FOR ENGINE AND BODY INTEGRAT-
ED UNIT
Refer to "Read Diagnostic Trouble Code" for infor-
mation about how to indicate DTC. <Ref. to IM(di-
ag)-8, Read Diagnostic Trouble Code (DTC).>
Subaru Select Monitor
3. COMMUNICATION LINE CHECK
NOTE:
The communication line between ECM and body
integrated unit can be checked in "System Opera-
tion Check Mode". This is referred to as "Commu-
nication line check".
1) Connect the Subaru Select Monitor.
2) On the «Main Menu» display screen, select the
{Each System Check}.
3) On the «System Selection Menu» display
screen, select the {Engine Control System}.
4) Select the [OK] after the information of engine
type is displayed.
5) On the «Engine Diagnosis» display screen, se-
lect the {System Operation Check Mode}.
6) On the «System operation check mode» display,
select the {security system}.
7) Start the communication line check.
8) Is «OK» displayed on screen?
If displayed, go to step 9).
If «NO», go to step 10).
9) After diagnostic results, it is determined that the
circuit is not shorted. Finish the communication line
check.
LAN00189
10) If a problem is detected, repair the trouble
cause. <Ref. to IM(diag)-20, DTC P1572 IMM CIR-
CUIT FAILURE (EXCEPT ANTENNA CIRCUIT),
Diagnostic Procedure with Diagnostic Trouble
Code (DTC).>
IM(diag)-7
IMMOBILIZER (DIAGNOSTICS)