Subaru B9 TRIBECA WX 2007 Manual page 353

asieps_tobira.book 24 ページ ２０１２年２月１０日 金曜日 午後３時２６分
EXTERIOR BODY PANELS
B: INSTALLATION
1. REAR GATE PANEL
1) Install in the reverse order of removal.
2) Install with attention to make uniform clearance
between rear gate panel and body. For the dimen-
sion of clearance, refer to "SPECIFICATION" in
"General Description". <Ref. to EB-2, SPECIFICA-
TION, General Description.>
Tightening torque:
25 N·m (2.6 kgf-m, 18.4 ft-lb)
2. REAR GATE DAMPER STAY
1) Prevent the rear gate from closing using prop or
the like.
CAUTION:
If the prop comes off, operators may get injured
and vehicle may get damaged. Make sure to
support the rear gate with secure material to
prevent injury or damage.
2) Install in the reverse order of removal.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to EB-11, REAR GATE PANEL, COMPO-
NENT, General Description.>
Rear Gate
C: DISPOSAL
1. REAR GATE DAMPER STAY
CAUTION:
Gas is colorless, odorless, and harmless. How-
ever, gas pressure may spray cutting powder or
oil. Be sure to wear dust-resistant goggles.
1) Cover with a vinyl sack as shown in the figure.
(1)
(1) Rear gate damper stay
(2) Vinyl sack
NOTE:
Prevent the vinyl sack from being caught by drill
cutting edge
2) Lift the body side slightly with piston rods fully
extended, and secure the body side with vise.
Drill a hole in 2 to 3 mm (0.08 to 0.12 in) diameter at
a point 10 to 200 mm (0.39 to 7.87 in) from door
side, and bleed rear gate damper stay gas stay
EB-00281 completely.
(5)
(1) Body side
(2) Door side
(3) 190 mm (7.48 in)
(4) 10 mm (0.39 in)
(5) Piston rod
(6) Cylinder
(7) Portion to be drilled
EB-24
(2)
EB-00031
(1) (2)
(3) (4)
(7)
(6)
EB-00032