Subaru B9 TRIBECA WX 2007 Manual page 163

asieps_tobira.book 88 ページ ２０１２年２月１０日 金曜日 午後３時２６分
AIRBAG SYSTEM (DIAGNOSTICS)
Step
1 CHECK POOR CONTACT OF CONNEC-
TORS.
Check for poor contact of the connectors
between the airbag control module, side airbag
module RH and the side airbag sensor RH.
2 CHECK SIDE AIRBAG MODULE.
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Disconnect the connector (AB25) from
(AB24), and connect the connector (1F) in test
harness F to connector (AB24).
3) Connect the airbag resistor to the connector
(3F) of test harness F.
4) Connect the battery ground terminal and
turn the ignition switch to ON.
3 CHECK AIRBAG REAR HARNESS RH (SIDE
AIRBAG MODULE HARNESS RH).
1) Turn the ignition switch to OFF, disconnect
the battery ground cable, and wait more than 20
seconds.
2) Disconnect the connector (AB26) from seat
belt pretensioner (RH).
3) Disconnect the connector (AB33) from cur-
tain airbag module (RH).
4) Disconnect the airbag resistor from test har-
ness F.
5) Disconnect the connector (AB18) from air-
bag control module.
6) Connect the connector (1U) in the test har-
ness U to connector (AB18).
7) Measure the resistance between connector
(3U) in the test harness U and connector (3F) in
the test harness F.
Connector & terminal
(3U) No. 20 — (3F) No. 4:
(3U) No. 18 — (3F) No. 3:
4 CHECK AIRBAG REAR HARNESS RH (SIDE
AIRBAG MODULE HARNESS RH).
Measure the resistance between connector
(3U) terminals in the test harness U.
Connector & terminal
(3U) No. 20 — (3U) No. 18:
5 CHECK AIRBAG REAR HARNESS RH (SIDE
AIRBAG MODULE HARNESS RH).
Measure the resistance between connector
(3U) in the test harness U and chassis ground.
Connector & terminal
(3U) No. 20 — Chassis ground:
(3U) No. 18 — Chassis ground:
6 CHECK AIRBAG CONTROL MODULE.
1) Connect all the connectors.
2) Erase the memory.
3) Perform the Inspection Mode.
4) Read the DTC.
Diagnostic Chart with Trouble Code
Is there poor contact?
Does the airbag warning light
illuminate for 6 seconds and go
off?
Is the resistance less than 10
Ω?
Is the resistance more than 1
MΩ?
Is the resistance more than 1
MΩ?
Is the same DTC displayed?
AB(diag)-88
Check Yes
Replace the airbag
rear harness RH
along with body
harness.
Replace the side
airbag module
(RH). <Ref. to AB-
16, REMOVAL,
Side Airbag Mod-
ule.>
Go to step 4.
Go to step 5.
Go to step 6.
Replace the airbag
control module.
<Ref. to AB-19,
Airbag Control
Module.>
No
Go to step 2.
Go to step 3.
Replace the airbag
rear harness RH
along with body
harness.
Replace the airbag
rear harness RH
along with body
harness.
Replace the airbag
rear harness RH
along with body
harness.
Go to step 7.