Subaru B9 TRIBECA WX 2007 Manual page 387

asieps_tobira.book 34 ページ ２０１２年２月１０日 金曜日 午後３時２６分
EXTERIOR/INTERIOR TRIM
11.Roof Molding
A: REMOVAL
1) Turn over the edge of the roof molding, and re-
move the inside clips with flat tip screwdriver by
sliding as arrow indicates.
Right side: slide towards the front of the vehicle.
Left side: slide towards the rear of the vehicle.
2) Pull the roof molding upward, and remove it from
vehicle body.
3) Remove the roof trim. <Ref. to EI-50, Roof
Trim.>
Roof Molding
4) Remove the nuts, and remove the roof carrier at-
tachment.
EI-01565
B: INSTALLATION
1) Install the roof carrier attachment.
Tightening torque:
10 N·m (1.0 kgf-m, 7.23 ft-lb)
EI-01380
2) Remove each clip from the roof molding, and in-
stall them to the vehicle side.
CAUTION:
Always replace clips damaged during removal
of the roof moulding with new clips.
3) Push the front edge of roof molding against the
front window, and install the positioning clip on the
front end to the rivet on the vehicle side.
(1)
(1) Windshield
(2) Positioning clips
(3) Roof molding
(4) Rivet
(5) Clip
EI-34
EI-00659
(3)
(2)
(5)
(4)
EI-01381