Subaru B9 TRIBECA WX 2007 Manual page 811

asieps_tobira.book 35 ページ ２０１２年２月１０日 金曜日 午後３時２６分
Front Door Latch and Door Lock Actuator Assembly
SECURITY AND LOCKS
7. Front Door Latch and Door
Lock Actuator Assembly
A: REMOVAL
1) Raise the front door glass to the top position.
2) Disconnect the ground cable from the battery.
3) Remove the front door trim. <Ref. to EI-35, RE-
MOVAL, Door Trim.>
4) Remove the cable from the front inner remote.
<Ref. to SL-33, REMOVAL, Front Inner Remote.>
5) Remove the sealing cover. <Ref. to EB-18, RE-
MOVAL, Front Sealing Cover.>
6) Remove the door sash. <Ref. to GW-9, REMOV-
AL, Front Door Glass.>
7) Remove the connection rod of the key cylinder
lever. (Driver's side only)
8) Remove the three screws.
SL-00697
9) Remove the front door latch and actuator as-
sembly, and disconnect the connector.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Make sure lock and unlock works correctly after in-
stallation.
C: INSPECTION
1) Check the rod and cable for deformation. When
it is deformed, straighten it because failure opera-
tions may occur. When it is unrepairable, replace
the front door latch and actuator assembly.
2) Check the lever, rod and cable for smooth oper-
ation.
SL-35