Subaru B9 TRIBECA WX 2007 Manual page 376

asieps_tobira.book 23 ページ ２０１２年２月１０日 金曜日 午後３時２６分
C: REPAIR
1. COATING METHOD FOR PP BUMPER
Process
Process name
No.
1 Bumper installation
2 Masking
Degreasing/clean-
3
ing
4 Primer paint
5 Drying
6 Top coat paint (I)
7 Drying
8 Top coat paint (II)
9 Drying
10 Inspection
Removal of mask-
11
ing
Front Bumper
Place the bumper on a paint worktable as
required. Use the paint worktable conforming
to inner shape of bumper if possible.
Mask specified part (black base) with masking tape. Use masking tape for PP (example, Nichiban
No. 533, etc.).
Clean all parts to be painted with white gasoline, normal alcohol, etc. to remove dirt, oil, fat, etc.
Apply primer to all parts to be painted, using spray gun. Use primer (clear).
Dry at normal temperature [10 — 15 min. at 20°C (68°F)].
In half-dried condition, PP primer paint is dissolved by solvent, e.g. thinner, etc.
Therefore, if dust or dirt must be removed, use ordinary alcohol etc.
Non-colored
Use section (block) paint for top coat.
• Paint to be used (for each color):
Solid paint
Hardener PB
Thinner T-301
• Mixture ratio:
Main agent : hardener = 4 : 1
• Viscosity: 10 — 13 sec./20°C (68°F)
• Film thickness: 35 — 45 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kg/cm , 36 — 50 psi)
Not required.
Not required.
60°C (140°F), 60 min. or 80°C (176°F), 30 min.
If higher than 80°C (176°F), PP may become be deformed. Keep maximum temperature below
80°C (176°F).
Check paint.
Remove the masking tape applied in procedure 2.
EI-23
EXTERIOR/INTERIOR TRIM
Job contents
(1)
(2)
(1) Bumper
(2) Set bumper section
Metallic paint
Use section (block) paint for top coat.
• Paint to be used (for each color):
Metallic paint
Hardener PB
Thinner T-306
• Mixture ratio:
Main agent : hardener = 10 : 1
• Viscosity: 10 — 13 sec./20°C (68°F)
• Film thickness: 15 — 20 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kg/cm , 36 — 50 psi)
Dry at normal temperature [at least 10 min. at
20°C (68°F)].
In half-dried condition, avoid dust, dirt.
Apply a clear coat to parts with top coat paint
(I), three times at 5 — 7 minutes intervals.
• Paint to be used:
Metallic paint
Hardener PB
Thinner T-301
• Mixture ratio:
Clear coat : hardener = 6 : 1
• Viscosity: 14 — 16 sec./20°C (68°F)
• Film thickness: 25 — 30 µ
• Spraying pressure: 245 — 343 kPa
2
(2.5 — 3.5 kg/cm , 36 — 50 psi)
EI-00234