2
General Power Meter Functions
Table 2-5
mode when in power or frequency sweep.
Table 2-5
Measurement functions
Hold off
Trigger delay
Measurement averaging
Gate setting
Channel offset
Hysteresis
Measurement types supported
Refer to the P-Series power meters Programming Guide for the commands
NOTE
usage details.
Example of command set:
SENSe:BUFFer:MTYPe "PEAK"
Power sweep mode
Power sweep is generally used in power level calibration setup where the
frequency is fixed, and the amplitude of the power source signal is swept. This
mode can be used to characterize the flatness, linearity or gain compression of a
device under test.
This feature is applicable for 8480 Series, N8480 Series, E-Series E4410,
NOTE
E-Series E9300, E-Series E9320 or P-Series N1920 sensor when connected.
104
shows the available measurement functions during normal and average
Power and frequency sweep measurement functions table
Peak, peak-to-average, average,
Normal Mode
Yes
Yes
—
Yes
—
—
minimun power
Keysight N1911A/1912A User's Guide
Average Mode
—
—
Yes
—
Yes
—
Average only