Table of Contents
Advertisement
Network User
Configuration
Scenarios
example, EXAMPLE\jose is on port 5, which is not in the port list), the
authorization fails and client EXAMPLE\jose is rejected.
The Mobility Profile feature is disabled by default. You must enable
Mobility Profile attributes on the WX switch to use it. You can enable or
disable the feature for the whole WX only. If the Mobility Profile feature is
disabled, all Mobility Profile attributes are ignored.
To put Mobility Profile attributes into effect on a WX, type the following
command:
WX1200# set mobility-profile mode enable
success: change accepted.
To display the name of each Mobility Profile and its ports, type the
following command:
WX1200# display mobility-profile
Mobility Profiles
Name
=========================
roses-profile
To remove a Mobility Profile, type the following command:
clear mobility-profile name
The following scenarios provide examples of ways in which you use AAA
commands to configure access for users:
"General Use of Network User Commands" on page 336
"Enabling RADIUS Pass-Through Authentication" on page 337
"Enabling PEAP-MS-CHAP-V2 Authentication" on page 338
"Enabling PEAP-MS-CHAP-V2 Offload" on page 339
"Combining EAP Offload with Pass-Through Authentication" on
page 340
"Overriding AAA-Assigned VLANs" on page 341
Network User Configuration Scenarios
Ports
AP 2
AP 3
AP 4
AP 6
335
Advertisement
Table of Contents
