Setting The Default Camera Position - Avaya XT Series Deployment Manual

• From the XT Series web interface, select select Store on the row of the new position
number.
4. To save your choice on the endpoint, press ok/menu.
The position number of the preset turns blue, indicating it was successfully stored.
On the web interface, the Assigned column now contains a check mark.
5. To delete a previously stored position with the XT Remote Control Unit, press its number
and then press the Delete
From the web interface, select Delete on the row of the position number.

Setting the Default Camera Position

About this task
You can make any of your preset positions the default position. Each time the system reboots, the
XT Remote Control Unit selects the default camera and positions the camera to the specified
preset.
Before you begin
Before you assign a camera position as the default, you must save a camera position, as
described in Saving PTZ Camera Positions
August 2020
Figure 87: Storing a camera preset
key.
on page 187.
Deployment Guide for Avaya XT Series
Comments on this document? infodev@avaya.com
Setting the Default Camera Position
189