Stack Virtual-Chassis-Id - Centrecom FS980M/9 Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING
- -
STACK VIRTUAL CHASSIS ID

stack virtual-chassis-id

Overview This command specifies the stack virtual chassis ID. The ID selected will determine
which virtual MAC address the stack will use. The MAC address assigned to a stack
must be unique within its network.
NOTE
Syntax stack virtual-chassis-id <id>
Mode Global Configuration
Usage The virtual-chassis-id entered will form the last 12 bits of a pre-selected MAC prefix
component; that is, 0000.cd37.0xxx. If you enable the stack virtual MAC address
feature (by using the
chassis-id command to select the virtual-chassis-id, then the stack will select a
virtual- chassis-id from a number within the assigned range.
Example To set the stack virtual-chassis-id to 63 use the commands
awplus#
awplus(config)#
This will result in a virtual MAC address of 0000.cd37.003f.
Related show running-config
Commands
show stack
switch provision (stack)
stack virtual-mac
613-50137-01 Rev A
™) C
TACK OMMANDS
: The command will not take effect until the switch has been rebooted.
Parameter Description
<id>
The value of the ID - enter a decimal number in the range 0 to 4095.
stack virtual-mac
configure terminal
stack virtual-chassis-id 63
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
command) without using the stack virtual-
1245