Show Auth Interface - Centrecom FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS

SHOW AUTH INTERFACE

show auth interface
Overview This command shows the status of port authentication on the specified interface,
which may be a static channel (or static aggregator) or a dynamic (or LACP)
channel group or a switch port.
Use the optional diagnostics parameter to show authentication diagnostics for
the specified interface. Use the optional sessionstatistics parameter to show
authentication session statistics for the specified interface. Use the optional
statistics parameter to show authentication diagnostics for the specified
interface. Use the optional supplicant (client device) parameter to show the
supplicant state for the specified interface.
show auth interface <interface-list>
Syntax
[diagnostics|sessionstatistics|statistics|supplicant [brief]]
Mode Privileged Exec
To display the Web based authentication status for port1.0.6, enter the
Example
command:
awplus#
If web-based authentication is not configured, the output will be
613-50137-01 Rev A
Parameter
<interface-list>
diagnostics
sessionstatistics Session statistics.
statistics
supplicant
brief
show auth interface port1.0.6
% Port-Control not configured on port1.0.6
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The interfaces or ports to configure. An interface-list can be:
• an interface (e.g. vlan2), a switch port (e.g. port1.0.6),
a static channel group (e.g. sa2) or a dynamic (LACP)
channel group (e.g. po2)
• a continuous range of interfaces, ports, static channel
groups or dynamic (LACP) channel groups separated by a
hyphen; e.g. vlan2-8, or port1.0.1-1.0.4, or
sa1-2, or po1-2
• a comma-separated list of the above; e.g.
port1.0.1,port1.0.4-1.0.6. Do not mix interface
types in a list
The specified interfaces must exist.
Diagnostics.
Statistics.
Supplicant (client device).
Brief summary of supplicant state.
1037