Auth Profile (Interface Configuration) - Centrecom FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS
(I C
AUTH PROFILE NTERFACE ONFIGURATION

auth profile (Interface Configuration)

Overview Use this command to attach a port authentication profile to the current interface.
Use the no variant of this command to detach a port authentication profile from
the current interface.
Syntax auth profile <profile-name>
no auth profile <profile-name>
Default No profile is attached by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port.
Usage This command attaches a authentication profile, created using the
(Global Configuration)
group, or a switch port.
You can only attach one profile to an interface at a time, use the no variant of the
command to detach a profile before attempting to attach another one.
Example To attach the authentication profile 'student' to port1.0.1, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To detach the authentication profile 'student' from port1.0.1, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
Related auth profile (Global Configuration)
Commands
613-50137-01 Rev A
)
Parameter
<profile-name>
command, to a static channel, a dynamic (LACP) channel
configure terminal
interface port1.0.1
configure terminal
interface port1.0.1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The name of the profile to attach to the current interface.
auth profile student
no auth profile student
auth profile
963