Switchport Resiliencylink - Centrecom FS980M/9 Command Reference Manual

V C S (VCS
IRTUAL HASSIS TACKING

SWITCHPORT RESILIENCYLINK

switchport resiliencylink
Overview This command configures the switch port to be a member of the stack resiliency
link VLAN. Note that this switchport will only be used for stack resiliency-link traffic
and will not perform any other function, or carry any other traffic.
The no variant of this command removes the switchport from the resiliency link
VLAN.
switchport resiliencylink
Syntax
no switchport resiliencylink
Mode Interface Configuration
Usage Note that a resiliency link cannot be part of a static or dynamic aggregator group.
Examples To set the resiliency link to be VLAN 4093:
First, use the stack resiliencylink command to create the resiliency-link vlan
vlan4093
awplus#
awplus(config)#
Next, use the switchport resiliencylink command to assign the resiliency-link
vlan to the port, in this case port1.0.1.
awplus#
awplus(config)#
awplus(config-if)#
Related stack resiliencylink
Commands
show stack resiliencylink
613-50137-01 Rev A
™) C
TACK OMMANDS
configure terminal
stack resiliencylink vlan4093
configure terminal
interface port1.0.1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
switchport resiliencylink
1249