Auth-Web-Server Blocking-Mode - Centrecom FS980M/9 Command Reference Manual

A C
UTHENTICATION OMMANDS
- - -
AUTH WEB SERVER BLOCKING MODE

auth-web-server blocking-mode

Overview Use this command to enable blocking mode for the Web-Authentication server.
The blocking mode displays an authentication success or failure screen
immediately from the response result from a RADIUS server.
Use the no variant of this command to disable blocking mode for the
Web-Authentication server.
auth-web-server blocking-mode
Syntax
no auth-web-server blocking-mode
Default By default, blocking mode is disabled for the Web-Authentication server.
Mode Global Configuration
Example To enable blocking mode for the Web-Authentication server, use the following
commands:
awplus#
awplus(config)#
To disable blocking mode for the Web-Authentication server, use the following
commands:
awplus#
awplus(config)#
Related auth-web-server redirect-delay-time
Commands
show auth-web-server
show running-config
613-50137-01 Rev A
configure terminal
auth-web-server blocking-mode
configure terminal
no auth-web-server blocking-mode
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
1001