Ip Address Dhcp; No Ip Address Dhcp - Centrecom FS980M/9 Command Reference Manual

D H C
YNAMIC OST ONFIGURATION

IP ADDRESS DHCP

ip address dhcp
Overview This command activates the DHCP client on the interface you are configuring. This
allows the interface to use the DHCP client to obtain its IP configuration details
from a DHCP server on its connected network.
The client-id and hostname parameters are identifiers that you may want to set in
order to interoperate with your existing DHCP infrastructure. If neither option is
needed, then the DHCP server uses the MAC address field of the request to identify
the host.
The DHCP client supports the following IP configuration options:
•
•
The no variant of this command stops the interface from obtaining IP
configuration details from a DHCP server.
Syntax ip address dhcp [client-id <interface>] [hostname <hostname>]

no ip address dhcp

Mode Interface Configuration for a VLAN interface.
Examples To set the interface vlan10 to use DHCP to obtain an IP address, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To stop the interface vlan10 from using DHCP to obtain its IP address, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
613-50137-01 Rev A
P (DHCP) C
ROTOCOL OMMANDS
Option 1 - the subnet mask for your device.
Option 51 - lease expiration time.
Parameter Description
<interface>
The name of the interface you are activating the DHCP client on. If
you specify this, then the MAC address associated with the
specified interface is sent to the DHCP server in the optional
identifier field.
Default: no default
<hostname>
The hostname for the DHCP client on this interface. Typically this
name is provided by the ISP.
Default: no default
configure terminal
interface vlan10
configure terminal
interface vlan10
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
ip address dhcp
no ip address dhcp
1445