Advertisement
E
P
S
THERNET
ROTECTION
WITCHED
EPSR
epsr
Overview
This command sets the timer values for an EPSR instance. These are only valid for
master nodes.
NOTE
master node. However, even if your switch cannot function as an EPSR master node,
you still may need to configure this command on whatever switch is the master within
your EPSR network.
epsr <epsr-instance> {hellotime <1-32767>|failovertime
Syntax
<2-65535> ringflaptime <0-65535>}
no epsr <epsr-instance>
CAUTION
instance.
Mode
EPSR Configuration
To set the hellotimer to 5 seconds for the EPSR instance called blue, use the
Examples
command:
awplus(config-epsr)#
NOTE
seconds.
To delete the EPSR instance called "blue", use the command:
awplus(config-epsr)#
613-50137-01 Rev A
R
(EPSR
™) C
ING
ING
OMMANDS
: This command will only run on switches that are capable of running as an EPSR
: Using the "no" variant of this command will remove the specified EPSR
Parameter
<epsr-instance>
hellotime <1-32767>
failovertime <2-65535>
ringflaptime <0-65535>
: When stacking is used with EPSR, the EPSR failovertime should be at least 5
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Name of the EPSR instance.
The number of seconds between the transmission of
health check messages.
The number of seconds that a master waits for a
returning health check message before entering the
failed state. The failover time should be greater
than twice the hellotime. This is to force the master
node to wait until it detects the absence of two
sequential healthcheck messages before entering
the failed state.
The minimum number of seconds that a master must
remain in the failed state.
epsr blue hellotime 5
no epsr blue
1256
Advertisement
Troubleshooting
