Epsr Mode Master Controlvlan Primary Port - Centrecom FS980M/9 Command Reference Manual

E P S
THERNET ROTECTION WITCHED

EPSR MODE MASTER CONTROLVLAN PRIMARY PORT

epsr mode master controlvlan primary port
Overview This command creates a master EPSR instance.
NOTE
master node. However, even if your switch cannot function as an EPSR master node,
you still need to configure this command on whatever switch is the master within your
EPSR network.
epsr <epsr-instance> mode master controlvlan <2-4094>
Syntax
primaryport <port>
NOTE
groups to the control VLAN within a single switch or stacked node. However, we advise
against this because in certain situations it can produce unpredictable results.
Mode EPSR Configuration
To create a master EPSR instance called blue with vlan2 as the control VLAN and
Example
port1.0.1 as the primary port, use the command:
awplus(config-epsr)#
primaryport port1.0.1
Related epsr mode transit controlvlan
Commands
show epsr
613-50137-01 Rev A
R (EPSR ™) C
ING ING OMMANDS
: This command will only run on switches that are capable of running as an EPSR
Parameter
<epsr-instance>
mode
master
controlvlan
<2-4094>
primaryport
<port>
: The software allows you to configure more than two ports or static channel
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Name of the EPSR instance.
Determines the node is acting as a master.
Sets switch to be the master node for the named EPSR ring.
The VLAN that will transmit EPSR control frames.
VLAN id.
Primary port for the EPSR instance.
The primary port. The port may be a switch port (e.g.
port1.0.4) or a static channel group (e.g. sa2). It cannot
be a dynamic (LACP) channel group.
epsr blue mode master controlvlan vlan2
1260