Atmf Controller - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF CONTROLLER

atmf controller
Overview Use this command to configure the device as an AMF controller. This enables you
to split a large AMF network into multiple areas.
The number of areas supported on a controller depends on the license installed on
that controller.
Syntax atmf controller
no atmf controller
Mode Global configuration
Usage A valid AMF license must be available before this command can be applied.
Example To configure the node named controller-1 as an AMF controller, use the
commands:
controller-1#
controller-1(config)#
To stop the node named controller-1 from being an AMF controller, use the
commands:
controller-1#
controller-1(config)#
Related atmf area
Commands
show atmf
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
configure terminal
configure terminal
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
atmf controller
no atmf controller
1310