Advertisement
E
P
S
THERNET
ROTECTION
WITCHED
EPSR MODE TRANSIT CONTROLVLAN
epsr mode transit controlvlan
Overview
This command creates a transit EPSR instance.
epsr <epsr-instance> mode transit controlvlan <2-4094>
Syntax
NOTE
groups to the control VLAN within a single switch or stacked node. However, we advise
against this because in certain situations it can produce unpredictable results.
If the control VLAN contains more than two ports (or static channels) an algorithm
selects the two ports or channels with the lowest number to be the ring ports. However
if the switch has only one channel group is defined to the control vlan, EPSR will not
operate on the secondary port.
EPSR does not support Dynamic link aggregation (LACP).
Mode
EPSR Configuration
To create a transit EPSR instance called blue with vlan2 as the control VLAN, use
Example
the command:
awplus(config-epsr)#
Related
epsr mode master controlvlan primary port
Commands
epsr mode transit controlvlan
show epsr
613-50137-01 Rev A
R
(EPSR
™) C
ING
ING
OMMANDS
Parameter
<epsr-instance>
mode
transit
controlvlan
<2-4094>
: The software allows you to configure more than two ports or static channel
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Name of the EPSR instance.
Determines the node is acting as a transit node.
Sets switch to be the transit node for the named EPSR ring.
The VLAN that will transmit EPSR control frames.
VLAN id.
epsr blue mode transit controlvlan vlan2
1261
Advertisement
Troubleshooting
