Snmp-Server Legacy-Ifadminstatus - Centrecom FS980M/9 Command Reference Manual

SNMP C
OMMANDS
- -
SNMP SERVER LEGACY IFADMINSTATUS

snmp-server legacy-ifadminstatus

Overview Use this command to set the ifAdminStatus to reflect the operational state of the
interface, rather than the administrative state.
The no variant of this command sets the ifAdminStatus to reflect the
administrative state of the interface.
Syntax snmp-server legacy-ifadminstatus
no snmp-server legacy-ifadminstatus
Default Legacy ifAdminStatus is turned off by default, so by default the SNMP
ifAdminStatus reflects the administrative state of the interface.
Mode Global Configuration
Usage Note that if you enable Legacy ifAdminStatus, the ifAdminStatus will report a link's
status as Down when the link has been blocked by a process such as loop
protection.
Example To turn on Legacy ifAdminStatus, use the command:
awplus#snmp-server legacy-ifadminstatus
Related show interface
Commands
613-50137-01 Rev A Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
1505