Type Stack Disabled-Master - Centrecom FS980M/9 Command Reference Manual

T C
RIGGER OMMANDS
-
TYPE STACK DISABLED MASTER

type stack disabled-master

Overview This command (configured to the stack) configures a trigger to activate on a stack
member if it becomes the disabled master.
A disabled master has the same configuration as the active master, but has all its
links shutdown.
Although this command could activate any trigger script, the intention here is that
the script will reactivate the links from their previously shutdown state, to enable
the user to manage the device. An appropriate trigger script must already exist
that will apply the
CAUTION
master and stack members are disabled at their stack member termination when
operating in the fallback configuration. Otherwise, the trunked ports will not function
correctly on the device that is connected downstream.
type stack disabled-master
Syntax
Mode Trigger Configuration
To configure trigger 82 to activate on a device if it becomes the disabled master,
Examples
use the commands. These commands enter the Trigger Configuration mode for
trigger 82, specify the trigger type, and then specify the script to run.
awplus#
awplus(config)#
awplus(config-trigger)#
awplus(config-trigger)#
awplus(config-trigger)#
Related stack disabled-master-monitoring
Commands
trigger
type stack disabled-master
type stack member
type stack link
613-50137-01 Rev A
shutdown command on the deactivated links.
: It is important that any ports that are configured as trunked ports across
configure terminal
trigger 82
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
type stack disabled master
script 1 flash:/disabled.scp
exit
1675