Lldp Holdtime-Multiplier - Centrecom FS980M/9 Command Reference Manual

LLDP C
OMMANDS
-
LLDP HOLDTIME MULTIPLIER

lldp holdtime-multiplier

Overview This command sets the holdtime multiplier value. The transmit interval is
multiplied by the holdtime multiplier to give the Time To Live (TTL) value that is
advertised to neighbors.
The no variant of this command sets the multiplier back to its default.
Syntax lldp holdtime-multiplier <2-10>
no lldp holdtime-multiplier
Default The default holdtime multiplier value is 4.
Mode Global Configuration
Usage The Time-To-Live defines the period for which the information advertised to the
neighbor is valid. If the Time-To-Live expires before the neighbor receives another
update of the information, then the neighbor discards the information from its
database.
Examples To set the holdtime multiplier to 2, use the commands:
awplus#
awplus(config)#
To set the holdtime multiplier back to its default, use the commands:
awplus#
awplus(config)#
Related show lldp
Commands
613-50137-01 Rev A
Parameter
<2-10>
configure terminal
lldp holdtime-multiplier 2
configure terminal
no lldp holdtime-multiplier 2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The multiplier factor.
1521