Centrecom FS980M/9 Command Reference Manual page 970

A C
UTHENTICATION OMMANDS
-
AUTH SUPPLICANT IP
Default No supplicant IP address for port authentication exists by default until first created
with the auth supplicant-ip command. The defaults for parameters applied are as
shown in the table above.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, a
switch port, or Authentication Profile.
Examples To add the supplicant IP address 192.168.10.0/24 to force authorized port control
for interface port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
port-control force-authorized
To delete the supplicant IP address 192.168.10.0/24 for interface port1.0.2, use the
commands:
awplus#
awplus(config)#
awplus(config-if)#
To disable reauthentication for the supplicant(s) IP address 192.168.10.0/24 for
interface port1.0.2, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
reauthentication
To add the supplicant IP address 192.168.10.0/24 to force authorized port control
for auth profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-auth-profile)#
192.168.10.0/24 port-control force-authorized
To disable reauthentication for the supplicant IP address 192.168.10.0/24, for auth
profile 'student', use the commands:
awplus#
awplus(config)#
awplus(config-if)#
reauthentication
Related show auth
Commands
show dot1x
show dot1x interface
show running-config
613-50137-01 Rev A
configure terminal
interface port1.0.2
auth supplicant-ip 192.168.10.0/24
configure terminal
interface port1.0.2
no auth supplicant-ip 192.168.10.0/24
configure terminal
interface port1.0.2
no auth supplicant-ip 192.168.10.0/24
configure terminal
auth profile student
configure terminal
auth profile student
no auth supplicant-ip 192.168.10.0/24
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
auth supplicant-ip
970