Dot1X Port-Control - Centrecom FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1 -
DOT X PORT CONTROL

dot1x port-control

Overview This command enables 802.1X port authentication on the interface specified, and
sets the control of the authentication port.
The no variant of this command disables the port authentication on the interface
specified.
Syntax dot1x port-control {force-unauthorized|force-authorized|auto}
no dot1x port-control
Default 802.1X port control is disabled by default.
Mode Interface Configuration for a static channel, a dynamic (LACP) channel group, or a
switch port; or Authentication Profile mode.
Usage Use this command to force a port state.
When port-control is set to auto, the 802.1X authentication feature is executed on
the interface, but only if the aaa authentication dot1x command has been issued.
To enable port authentication on the interface port1.0.2, use the commands:
Examples
awplus#
awplus(config)#
awplus(config-if)#
To enable port authentication force authorized on the interface port1.0.2, use
the commands:
awplus#
awplus(config)#
awplus(config-if)#
613-50137-01 Rev A
Parameter
force-unauthorized
force-authorized
auto
configure terminal
interface port1.0.2
configure terminal
interface port1.0.2
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Force the port state to unauthorized.
Specify this to force a port to always be in an unauthorized
state.
Force the port state to authorized.
Specify this to force a port to always be in an authorized
state.
Allow the port client to negotiate authentication.
Specify this to enable authentication on the port.
dot1x port-control auto
dot1x port-control force-authorized
919