Access-List Standard (Named) - Centrecom FS980M/9 Command Reference Manual

IP 4 S A C
V OFTWARE CCESS ONTROL
- (
ACCESS LIST STANDARD NAMED

access-list standard (named)

Overview This command configures a standard named access-list that permits or denies
packets from a specific source IP address. You can either create a standard named
ACL together with an ACL filter entry in the Global Configuration mode, or you can
use the IPv4 Standard ACL Configuration mode for sequenced ACL filter entry after
first entering an access-list name.
The no variant of this command removes a specified standard named access-list.
access-list standard <standard-access-list-name>
Syntax
[list-name]
no access-list standard <standard-access-list-name>
Syntax access-list standard <standard-access-list-name> {deny|permit}
<source>
[deny|permit]
no access-list standard <standard-access-list-name>
{deny|permit} <source>
Mode Global Configuration
Default Any traffic controlled by a software ACL that does not explicitly match a filter is
denied.
613-50137-01 Rev A
L (ACL) C
IST OMMANDS
)
Parameter
<standard-access-list-name
>
Parameter Description
<standard-
Specify a name for the standard access-list.
access-list-
name>
deny
The access-list rejects packets that match the source filtering
specified with this command.
permit
The access-list permits packets that match the source filtering
specified with this command.
<source>
The source address of the packets. You can specify a single host, a
subnet, or all sources. The following are the valid formats for
specifying the source:
<ip-addr>/<prefix>
any
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Specify a name for the standard access-list.
An IPv4 address, followed by a
forward slash, then the prefix
length. This matches any source
IP address within the specified
subnet.
Matches any source IP address.
825