Sample-Size - Centrecom FS980M/9 Command Reference Manual

P -P C
ING OLLING OMMANDS
-
SAMPLE SIZE

sample-size

Overview This command sets the total number of pings that the polling instance inspects
when determining whether a device is unreachable. If the number of pings
specified by the fail-count command go unanswered within the inspected
sample, then the device is declared unreachable.
If the numbers set in this command and
unanswered pings must be consecutive. If the number set by this command is
greater than that set with the
reply to pings may be declared unreachable.
You cannot set this command's value lower than the
The polling instance uses the number of pings specified by the
command to determine when a device is reachable.
The no variant of this command resets this command to the default.
sample-size <1-100>
Syntax
no sample size
Default The default is 5.
Mode Ping-Polling Configuration
Examples To set the sample-size to 50 for ping-poll instance 43, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To reset sample-size to the default of 5 for ping-poll instance 43, use the
commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
613-50137-01 Rev A
Parameter Description
<1-100>
Number of pings that determines critical and up counts.
configure terminal
ping-poll 43
configure terminal
ping-poll 43
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
fail-count command are the same, the
fail-count command, a device that does not always
sample-size 50
no sample-size
fail-count value.
up-count
1694