Mls Qos Enable - Centrecom FS980M/9 Command Reference Manual

Q S C
O OMMANDS

MLS QOS ENABLE

mls qos enable
Overview Use this command to globally enable QoS on the switch or stack.
Use the no variant of this command to globally disable QoS and remove all QoS
configuration. The no variant of this command removes all class-maps,
policy-maps, and policers that have been created. Running the no mls qos
command will therefore remove all pre-existing QoS configurations on the switch.
Mode Global Configuration
mls qos enable
Syntax
no mls qos
Example To enable QoS on the switch, use the commands:
awplus#
awplus(config)#
613-50137-01 Rev A
configure terminal
mls qos enable
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
869