Storm-Protection - Centrecom FS980M/9 Command Reference Manual

Q S C
O OMMANDS
-
STORM PROTECTION

storm-protection

Overview Use this command to enable Policy Based Storm Protection (such as QSP - QoS
Storm Protection). Storm protection is activated as soon as a port is enabled.
However, it will only be functional after
set.
The no variant of this command disables Policy Based Storm Protection.
storm-protection
Syntax
no storm-protection
Default By default, storm protection is disabled.
Mode Policy Map Class Configuration
Examples To enable QSP on cmap2 in pmap2, use the following commands:
awplus#
awplus(config)#
awplus(config-pmap)#
awplus(config-pmap-c)#
To disable QSP on cmap2 in pmap2, use the following commands:
awplus#
awplus(config-pmap)#
awplus(config-pmap-c)#
Related storm-action
Commands
storm-downtime
storm-rate
storm-window
613-50137-01 Rev A
configure terminal
policy-map pmap2
class cmap2
storm-protection
policy-map pmap2
class cmap2
no storm-protection
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
storm-rate and storm-window have been
897