Advertisement
A
T
M
F
LLIED
ELESIS
ANAGEMENT
-
SWITCHPORT ATMF
LINK
switchport atmf-link
Overview
This command enables you to configure a port or aggregator to be an AMF
up/down link. Running this command will automatically place the port or
aggregator into trunk mode.
Use the no variant of this command to remove any AMF-link that may exist for the
selected port or aggregated link.
switchport atmf-link
Syntax
no switchport atmf-link
Mode
Interface Configuration for a switchport, a static aggregator or a dynamic channel
group.
Usage
Up/down links and virtual links interconnect domains in a vertical hierarchy, with
the highest domain being the core domain. In effect, they form a tree of
interconnected AMF domains. This tree must be loop-free. Therefore, you must
configure your links so that no rings are formed only from up/down links and/or
virtual links.
Within each domain, cross-links between AMF nodes define those nodes as
siblings within the same domain. You can form rings by combining cross-links with
up/down links and/or virtual links, as long as each AMF domain links upwards to
only a single parent domain. Each domain may link downwards to multiple child
domains.
Example
To make a switchport 1.0.1 an AMF up/down link, use the following commands:
Node_1#
Node_1(config)#
Node_1(config-if)#
613-50137-01 Rev A
™ (AMF) C
RAMEWORK
OMMANDS
configure terminal
interface port1.0.1
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
switchport atmf-link
1437
Advertisement
Troubleshooting
