Lldp Tx-Delay - Centrecom FS980M/9 Command Reference Manual

LLDP C
OMMANDS
-
LLDP TX DELAY

lldp tx-delay

Overview This command sets the value of the transmission delay timer. This is the minimum
time interval between transmitting LLDP advertisements due to a change in LLDP
local information.
The no variant of this command sets the transmission delay timer back to its
default setting.
lldp tx-delay <1-8192>
Syntax
no lldp tx-delay
Default The default transmission delay timer is 2 seconds.
Mode Global Configuration
Examples To set the transmission delay timer to 12 seconds, use the commands:
awplus#
awplus(config)#
To set the transmission delay timer back to its default, use the commands:
awplus#
awplus(config)#
Related lldp timer
Commands
show lldp
613-50137-01 Rev A
Parameter Description
<1-8192>
The transmission delay in seconds. The transmission delay cannot be
greater than a quarter of the transmit interval
configure terminal
lldp tx-delay 12
configure terminal
no lldp tx-delay
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
(lldp timer command).
1537