Advertisement
38
Introduction
This chapter provides an alphabetical reference for Allied Telesis Management
Framework™ (AMF) commands.
AMF master
Every AMF network must have at least one master node, which acts as the core of
nodes
the AMF network. Not all AlliedWare Plus devices are capable of acting as an AMF
master. See the
about AMF master support.
AMF edge
FS980M Series, GS900MX Series and XS900MX Series switches can only be used as
edge switches in an AMF network. The full management power and convenience
of AMF is available on these switches, but they can only link to one other AMF node.
They cannot form cross-links or virtual links.
AMF naming
When AMF is enabled on a device, it will automatically be assigned a host name. If
convention
a host name has already been assigned, by using the command
185, this will remain. If however, no host name has been assigned, then the name
applied will be the prefix, host_ followed (without a space) by the MAC address of
the device. For example, a device whose MAC address is 0016.76b1.7a5e will have
the name host_0016_76b1_7a5e assigned to it.
To efficiently manage your network using AMF, we strongly advise that you devise
a naming convention for your network devices, and accordingly apply an
appropriate hostname to each device in your AMF network.
AMF and STP
On AR-Series firewalls, you cannot use STP at the same time as AMF.
Command List
•
•
•
•
•
613-50137-01 Rev A
Framework™ (AMF)
AMF Feature Overview and Configuration Guide
"atmf
area" on page 1286
"atmf area
password" on page 1288
"atmf
backup" on page 1290
"atmf backup area-masters
"atmf backup area-masters
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Allied Telesis
Management
Commands
delete" on page 1291
enable" on page 1292
for information
hostname
on page
1282
Advertisement
Troubleshooting
