Advertisement
A
T
M
F
LLIED
ELESIS
ANAGEMENT
ATMF BACKUP ENABLE
atmf backup enable
Overview
This command enables automatic AMF backups on the AMF master node that you
are connected to. By default, automatic backup starts at 3:00 AM. However, this
schedule can be changed by the
initiated and stored only on the master nodes.
Use the no variant of this command to disable any AMF backups that have been
scheduled and previously enabled.
atmf backup enable
Syntax
no atmf backup enable
Default
Automatic AMF backup functionality is enabled on the AMF master when it is
configured and external media, i.e. an SD card or a USB storage device or remote
server, is detected.
Mode
Global Configuration
Usage
A warning message will appear if you run the
either insufficient or marginal memory availability on your external storage device.
You can use the command
of space available on your external storage device.
We recommend using the ext3 or ext4 filesystem on external media that are used
for AMF backups.
Example
To turn on automatic AMF backup, use the following command:
AMF_Master_1#
AMF_Master_1(config)#
Related
show atmf
Commands
show atmf backup
atmf backup
atmf backup now
atmf enable
613-50137-01 Rev A
™ (AMF) C
RAMEWORK
OMMANDS
configure terminal
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
atmf backup
command. Note that backups are
atmf backup enable
show atmf backup
on page 1384 to check the amount
atmf backup enable
command with
1297
Advertisement
Troubleshooting
