Advertisement
AAA C
OMMANDS
-
SERVER NAME
CHECK
server name-check
Overview
This command sets the global behavior for certificate name-checking for the
RadSecProxy AAA application to on. This behavior will be used for all servers
associated with the application that do not specify a behavior on a per-server basis.
If name-checking is enabled, the Common Name portion of the subject field of the
client's X.509 certificate must match the domain name or IP address specified in
the server (radsecproxy-aaa) command.
Use the no variant of this command to set the global behavior for certificate name
checking to off
server name-check
Syntax
no server name-check
Default
Certificate name checking is on by default.
Mode
RadSecProxy AAA Configuration Mode
Example
Disable certificate name checking globally with the following command:
awplus#
awplus(config)#
awplus(config-radsecproxy-aaa)#
Related
proxy-port
Commands
radius-secure-proxy aaa
server (radsecproxy-aaa)
server trustpoint
613-50137-01 Rev A
configure terminal
radius-secure-proxy aaa
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
no server name-check
1093
Advertisement
Troubleshooting
