Trap - Centrecom FS980M/9 Command Reference Manual

T C
RIGGER OMMANDS

TRAP

trap
Overview This command enables the specified trigger to send SNMP traps.
Use the no variant of this command to disable the sending of SNMP traps from the
specified trigger.
Syntax trap
no trap
Default SNMP traps are enabled by default for all defined triggers.
Mode Trigger Configuration
Usage You must configure SNMP before using traps with triggers. For more information,
see:
•
•
•
Since SNMP traps are enabled by default for all defined triggers, a common usage
will be for the no variant of this command to disable SNMP traps from a specified
trap if the trap is only periodic. Refer in particular to AT-TRIGGER-MIB in the
Support for Allied Telesis Enterprise_MIBs_in AlliedWare Plus
information about the relevant SNMP MIB.
Examples To enable SNMP traps to be sent from trigger 5, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
To disable SNMP traps being sent from trigger 205, use the commands:
awplus#
awplus(config)#
awplus(config-trigger)#
Related trigger
Commands
show trigger
613-50137-01 Rev A
Support for Allied Telesis Enterprise_MIBs_in_AlliedWare
information about which MIB objects are supported.
the SNMP Feature Overview and
the SNMP Commands
configure terminal
trigger 5
configure terminal
trigger 205
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Configuration_Guide.
chapter.
trap
no trap
Plus, for
for further
1663