Show Atmf Detail - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

SHOW ATMF DETAIL

show atmf detail
Overview This command displays details about an AMF node. It can only be run on AMF
master and controller nodes.
show atmf detail
Syntax
Mode Privileged Exec
Example 1 To display the AMF node1 information in detail, use the command:
controller-1#
A typical output screen from this command is shown below:
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
detail
show atmf detail
atmf-1#show atmf detail 
ATMF Detail Information: 

Network Name
Network Mtu
Node Name
Node Address
Node ID
Node Depth
Domain State
Recovery State
Log Verbose Setting

Management VLAN 
VLAN ID
Management Subnet
Management IP Address
Management Mask
Management IPv6 Address
Management IPv6 Prefix Length

Domain VLAN 
VLAN ID
Domain Subnet
Domain IP Address
Domain Mask
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Displays output in greater depth.
: Test_network 
: 1300
: controller-1 
: controller-1.atmf 
: 342 
: 0 
: BackupDomainController
: None 
: Verbose 
: 4000 
: 172.31.0.0 
: 172.31.1.86
: 255.255.128.0 
: fd00:4154:4d46:1::156
: 64
: 4091
: 172.31.128.0
: 172.31.129.86
: 255.255.128.0
1392