Atmf Management Vlan - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF MANAGEMENT VLAN

atmf management vlan
Overview The AMF management VLAN is created when the AMF network is first initiated and
is assigned its default VID of 4092. This command enables you to change the VID
from this default value.
The AMF management vlan is one of the internal VLANs that are used to
communicate information about the state of the AMF network between nodes.
AMF uses its internal VLANS (such as the management VLAN and the domain
VLAN) to communicate its inter nodal network status information. These VLANs
must be reserved for AMF and not used for other purposes.
If you assign a VLAN ID to this VLAN (i.e. change its value from the default of 4092)
then you will need to do this separately on every device within the AMF. The AMF
management subnet will then be applied to this new VID when all devices within
the AMF network are next rebooted.
Use the no variant of this command to restore the VID to the default of 4092.
atmf management vlan <2-4090>
Syntax
no atmf management vlan
Default VLAN ID default is 4092
NOTE
You can use the "no" variant of this command to reset the VLAN to its default value.
mode Global Configuration
Usage You can use this command to change the management VLAN to meet your
network's requirements and standards, particularly in situations where the default
address value is unacceptable.
NOTE
value configured by the command
description for further details.
Examples To change the AMF management VLAN to 4090 use the following commands:
VCF-1#
VCF-1(config)#
To reset the AMF domain VLAN to its default of 4092, use the following commands:
VCF-1#
VCF-1(config)#
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<2-4090>
: Although the value applied by default lies outside the user configurable range.
: This VLAN will automatically be assigned an IP subnet address based on the
configure terminal
atmf management vlan 4090
configure terminal
no atmf management vlan 4090
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The VID assigned tro the AMF management VLAN.
atmf management subnet. Refer to this command
1323