Show Atmf Area Nodes - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

SHOW ATMF AREA NODES

show atmf area nodes
Overview Use this command to display summarized information about an AMF controller's
remote nodes.
Note that this command can only be run from a controller node.
Syntax show atmf area nodes [<area-name> [<node-name>]]
Mode Privileged Exec
Usage If you do not limit the output to a single area or node, this command lists all remote
nodes that the controller is aware of. This can be a very large number of nodes.
Example To show summarized information about all the nodes the controller is aware of,
use the command:
controller-1#
The following figure shows partial example output from running this command.
Table 11: Output from the show atmf area nodes command
controller-1#show atmf area nodes 

Wellington Area Node Information: 

Node Device
Name Type
---------------------------------------------------------------------------- 
well-gate x210-24GT
well-master AT-x930-28GPX

Wellington node count 2

...
Table 12: Parameter definitions from the show atmf area nodes command
Parameter
Node Name
Device Type
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<area-name>
Displays information about nodes in the specified area.
<node-name>
Displays information about the specified node.
show atmf area nodes
ATMF
Master
N
Y
Definition
The name assigned to a particular node.
The Product series name.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
SC Parent
N well-master
N none
Node 
Depth 
1 
0 
1379