Show Atmf Area Guests-Detail - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
SHOW ATMF AREA GUESTS DETAIL

show atmf area guests-detail

Overview This command displays the local and remote guest information from an AMF
controller.
show atmf area guests-detail [<area-name> [<node-name>]]
Syntax
Default N/A.
Mode Privileged Exec
Example To display detailed information for all guest nodes attached to "node1", which is
located within the area named "northern", use the following command:
AMF_controller#show atmf area guests-detail northern node1
Output Figure 38-9: Example output from the show atmf guest detail command.
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<area-name>
The name assigned to the AMF area. An area is an AMF network
that is under the control of an AMF Controller.
<node-name>
The name assigned to the network node.
#show atmf guest detail

Node Name
Port Name
Ifindex
Guest Description
Device Type
Configuration Mismatch
Backup Supported
MAC Address
IP Address
IPv6 Address
HTTP Port
Firmware Version
Node Name
Port Name
Ifindex
Guest Description
Device Type
Configuration Mismatch
Backup Supported
MAC Address
IP Address
IPv6 Address
HTTP Port
Firmware Version
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
: Node1
: port1.0.5
: 5005
: tq4600
: AT-TQ4600
: No
: Yes
: eccd.6df2.da60
: 192.168.4.50
: Not Set
: 80
:
: poe
: port1.0.6
: 5006
: tq3600
: AT-TQ2450
: No
: Yes
: 001a.eb3b.cb80
: 192.168.4.9
: Not Set
: 80
:
1377