A
T
M
F
LLIED
ELESIS
ANAGEMENT
-
SHOW ATMF AREA NODES
DETAIL
show atmf area nodes-detail
Overview
Use this command to display detailed information about an AMF controller's
remote nodes.
Note that this command can only be run from a controller node.
Syntax
show atmf area nodes-detail [<area-name> [<node-name>]]
Mode
Privileged Exec
Usage
If you do not limit the output to a single area or node, this command displays
information about all remote nodes that the controller is aware of. This can be a
very large number of nodes.
Example
To show information about all the nodes the controller is aware of, use the
command:
controller-1#
The following figure shows partial example output from running this command.
Table 13: Output from the show atmf area nodes-detail command
613-50137-01 Rev A
™ (AMF) C
RAMEWORK
OMMANDS
Parameter
Description
<area-name>
Displays detailed information about nodes in the specified area.
<node-name>
Displays detailed information about the specified node.
show atmf area nodes-detail
controller-1#show atmf area nodes-detail
Wellington Area Node Information:
Node name
well-gate
Parent node name
Domain id
Board type
Distance to core
Flags
Extra flags
MAC Address
Node name well-master
Parent node name
Domain id
Board type
Distance to core
Flags
Extra flags
MAC Address
...
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
: well-master
: well-gate's domain
: 368
: 1
: 50
: 0x00000006
: 001a.eb56.9020
: none
: well-master's domain
: 333
: 0
: 51
: 0x0000000c
: eccd.6d3f.fef7
1381