Reboot Rolling - Centrecom FS980M/9 Command Reference Manual

Fs980m series fast ethernet managed access switches reference for alliedware plus version 5.4.6-2.x

REBOOT ROLLING

reboot rolling

This command reboots a stack in a rolling sequence to minimize downtime.

The stack master is rebooted, causing the remaining stack members to failover and

elect a new master. The rebooted unit remains separate from the remaining stack

and boots up as a stand-alone unit. Once the rebooted unit has finished running

its configuration and has brought its ports up, it reboots all the remaining stack

members at once.

reboot rolling

Privileged Exec

If you are upgrading to a new software version, the new version must also support

rollling reboot.

5 seconds to avoid any broadcast storms during failover. Broadcast storms may occur

if the switch cannot failover quickly enough before the EPSR failovertime expires. For

further information about EPSR failovertime, see the

To rolling reboot the stack, use the following commands:

Continue the rolling reboot of the stack? (y/n):

After running this command, the stack master will reboot immediately with the

configuration file settings. The remaining stack members will then reboot once the

master has finished re-configuring.

Continue the rolling reboot of the stack? (y/n):

613-50137-01 Rev A

: When stacking is used with EPSR, the EPSR failovertime must be set to at least

reboot rolling

Command Reference for FS980M Series

AlliedWare Plus™ Operating System - Version 5.4.6-2.x