Dot1X Eap - Centrecom FS980M/9 Command Reference Manual

802.1X C
OMMANDS
1
DOT X EAP

dot1x eap

Overview This command selects the transmit mode for the EAP packet. If the authentication
feature is not enabled then EAP transmit mode is not enabled. The default setting
discards EAP packets.
dot1x eap {discard|forward|forward-untagged-vlan|forward-vlan}
Syntax
The transmit mode is set to discard EAP packets by default.
Default
Mode Global Configuration
To set the transmit mode of EAP packet to forward to forward EAP packets to all
Examples
ports on the switch, use the commands:
awplus#
awplus(config)#
To set the transmit mode of EAP packet to discard to discard EAP packets, use
the commands:
awplus#
awplus(config)#
To set the transmit mode of EAP packet to forward-untagged-vlan to
forward EAP packets to ports with the same untagged vlan, use the commands:
awplus#
awplus(config)#
To set the transmit mode of EAP packet to forward-vlan to forward EAP
packets to ports with the same vlan, use the commands:
awplus#
awplus(config)#
613-50137-01 Rev A
Parameter
discard
forward
forward-untagged-vlan
forward-vlan
configure terminal
dot1x eap forward
configure terminal
dot1x eap discard
configure terminal
dot1x eap forward-untagged-vlan
configure terminal
dot1x eap forward-vlan
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
Discard.
Forward to all ports on the switch.
Forward to ports with the same untagged VLAN.
Forward to ports with the same VLAN.
909