Advertisement
LLDP C
OMMANDS
-
LLDP MANAGEMENT
ADDRESS
lldp management-address
Overview
This command sets the IPv4 address to be advertised to neighbors (in the
Management Address TLV) via the specified ports. This address will override the
default address for these ports.
The no variant of this command clears the user-configured management IP
address advertised to neighbors via the specified ports. The advertised address
reverts to the default.
lldp management-address <ipaddr>
Syntax
no lldp management-address
Default
The local loopback interface primary IPv4 address if set, else the primary IPv4
interface address of the lowest numbered VLAN the port belongs to, else the MAC
address of the device's baseboard if no VLAN IP addresses are configured for the
port.
Mode
Interface Configuration
Usage
To see the management address that will be advertised, use the
interface
Examples
To set the management address advertised by ports 1.0.1 and 1.06, to be
192.168.1.6, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To clear the user-configured management address advertised by ports 1.0.1 and
1.0.6, and revert to using the default address, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related
show lldp interface
Commands
show lldp local-info
613-50137-01 Rev A
Parameter
<ipaddr>
command or
show lldp local-info
configure terminal
interface port1.0.1,port1.0.6
configure terminal
interface port1.0.1,port1.0.6
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The IPv4 address to be advertised to neighbors, in dotted
decimal format. This must be one of the IP addresses already
configured on the device.
command.
lldp management-address 192.168.1.6
no lldp management-address
show lldp
1522
Advertisement
Troubleshooting
