Atmf Working-Set - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT
-
ATMF WORKING SET

atmf working-set

Overview Use this command to execute commands across an individually listed set of AMF
nodes or across a named group of nodes.
Note that this command can only be run on a master node.
Use the no variant of this command to remove members or groups from the
current working-set.
atmf working-set {[<node-list>]|[group
Syntax
{<group-list>|all|local|current}]}
no atmf working-set {[<node-list>]|[group <group-list>]}
Mode Privileged Exec
Usage You can put AMF nodes into groups by using the
command.
This command opens a session on multiple network devices. When you change the
working set to anything other than the local device, the prompt will change to the
AMF network name, followed by the size of the working set, shown in square
brackets. This command has to be run at privilege level 15.
In addition to the user defined groups, the following system assigned groups are
automatically created:
•
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter Description
<node-list>
A comma delimited list (without spaces) of nodes to be included
in the working-set.
group
The AMF group.
<group-list>
A comma delimited list (without spaces) of groups to be included
in the working-set. Note that this can include either defined
groups, or any of the Automatic, or Implicit Groups shown earlier
in the bulleted list of groups.
all
All nodes in the AMF.
local
Local node
Running this command with the parameters group local will
return you to the local prompt and local node connectivity.
current
Nodes in current list.
Implicit Groups
– local: The originating node.
– current: All nodes that comprise the current working-set.
– all: All nodes in the AMF.
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
atmf group (membership)
1354