Active (Ping-Polling) - Centrecom FS980M/9 Command Reference Manual

P -P C
ING OLLING OMMANDS
( - )
ACTIVE PING POLLING

active (ping-polling)

Overview This command enables a ping-poll instance. The polling instance sends ICMP echo
requests to the device with the IP address specified by the
command.
By default, polling instances are disabled. When a polling instance is enabled, it
assumes that the device it is polling is unreachable.
The no variant of this command disables a ping-poll instance. The polling instance
no longer sends ICMP echo requests to the polled device. This also resets all
counters for this polling instance.
active
Syntax
no active
Mode Ping-Polling Configuration
Examples To activate the ping-poll instance 43, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
To disable the ping-poll instance 43 and reset its counters, use the commands:
awplus#
awplus(config)#
awplus(config-ping-poll)#
Related debug ping-poll
Commands
ip (ping-polling)
ping-poll
show ping-poll
613-50137-01 Rev A
configure terminal
ping-poll 43
configure terminal
ping-poll 43
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
active
no active
ip (ping-polling)
1684