Atmf Provision Node Locate - Centrecom FS980M/9 Command Reference Manual

A T M F
LLIED ELESIS ANAGEMENT

ATMF PROVISION NODE LOCATE

atmf provision node locate
Overview This command changes the present working directory to the directory of a
provisioned node. This makes it easier to edit files and create a unique provisioned
node in the backup.
This command can only be run on AMF master nodes.
Syntax atmf provision node <nodename> locate
Mode Privileged Exec
Usage This command is only available on master nodes in the AMF network. The
command will only work if the provisioned node specified in the command has
already been set up. Otherwise, an error message is shown when the command is
run.
NOTE
directory, typically flash.
Example To change the working directory that happens to be on device1 to the directory of
provisioned node device2, use the following command:
device1#
The directory of the node device2 should now be the working directory. You can
use the command
Figure 38-6: Sample output from the pwd command
The output above shows that the working directory is now the flash of device2.
Related atmf provision node create
commands
atmf provision node clone
pwd
613-50137-01 Rev A
™ (AMF) C
RAMEWORK OMMANDS
Parameter
<nodename>
: We advise that after running this command, you return to a known working
atmf provision node device2 locate
pwd

device2#pwd
card:/atmf/building_2/nodes/device2/flash
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.6-2.x
Description
The name of the provisioned node.
to check this, as shown in the following figure.
1338