Adding A User Vlan To Multiple Multicast Vlans - Huawei Quidway s3700 series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Multicast
IGMP snooping is enabled globally.
Step 3 Run:
vlan vlan-id
A user VLAN is created and its view is displayed.
Step 4 Run:
igmp-snooping enable
IGMP snooping is enabled in the user VLAN.
Step 5 Run:
multicast flow-trigger enable
The user VLAN is enabled to be added to multiple multicast VLANs.
The multicast flow-trigger enable command can only be used in user VLANs.
----End

3.5.3 Adding a User VLAN to Multiple Multicast VLANs

Prerequisite
If a user in a user VLAN wants to receive multicast data in multiple multicast VLANs, repeat
the following steps to add the user VLAN to multiple multicast VLANs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vlan vlan-id
A VLAN is created and its view is displayed.
Step 3 Run:
igmp-snooping enable
IGMP snooping is enabled in the VLAN.
Step 4 Run:
multicast-vlan enable
Multicast VLAN replication is enabled and the current VLAN is configured as a multicast
VLAN.
After IP multicast is configured on the S3700, no multicast VLAN can be configured.
Step 5 Run:
multicast-vlan user-vlan { { vlan-id1 [ to vlan-id2 ] } & <1-10> }
User VLANs are added to the multicast VLAN.
Issue 01 (2011-10-26) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Multicast VLAN Replication Configuration
46