Configuration Examples; Example For Configuring A Stack In A Ring Topology - Huawei Quidway S3700 Series Configuration Manual

Quidway S3700 Series Ethernet Switches
Configuration Guide - Device Management
l
----End
Example
You can use the display stack command to check stack IDs and priorities of member switches
in a stack.
<Quidway> display stack
Stack topology type : Link
Stack system MAC: 0018-82b1-6eb4
MAC switch delay time: 2 min
Stack reserve vlanid : 4093
slot#
------
You can use the display stack configuration command to check the default stack ID and stack
priority when the stack member starts this time and next time.
<Quidway> display stack configuration
Current slot-id
----------------

3.6 Configuration Examples

This section provides an example for configuring a stack in a ring topology.

3.6.1 Example for Configuring a Stack in a Ring Topology

Networking Requirements
As shown in
topology. The stack system is automatically created. Switch A functions as the master switch,
whereas Switch B functions as a standby switch. After the active/standby switchover, the MAC
address of the stack system is immediately switched. To avoid updating MAC addresses of the
stack system frequently and wasting system resources, set the MAC address switchover time of
the stack system to 1 minute after the active/standby switchover.
Issue 01 (2011-07-15)
Run the display stack configuration command to check the default stack ID and stack
priority when the stack member starts this time and next time.
role Mac address
---- --------------
0 Master 0018-82b1-6eb4
1 Standby 0018-82b1-6eba
Next slot-id
-------------
0
1
Figure 3-5, Switch A, Switch B, Switch C, and Switch D form a stack in a ring
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Priority
------
200
150
Current Priority
----------------------
8 200
3 150
Device type
-------
S3700
S3700
Next Priority
-------------
200
150
3 Stacking
37