Reading 32-Bit Decimal Displays - YASKAWA SGMJV User Manual

8 Monitor Modes (Un
8.3

Reading 32-bit Decimal Displays

This section describes how to read parameters displayed in 32-bit decimal on the Panel Operator.
Step
1
2
3
4
5
6
The method for reading the display is summarized below.
Top two digits
The number of pulses between -2147483648 (-2
the number of pulses is outside this range, the display will change as follows:
• The displayed value will change to 2147483647 when the number of pulses decreases by one from
-2147483648. Thereafter, the displayed value will decrease according to the number of pulses.
• The displayed value will change to -2147483648 when the number of pulses increases by one from
2147483647. Thereafter, the displayed value will increase according to the number of pulses.
8-4
)
Display after
Operation
MODE/SET
MODE/SET
Lower 4 digits
MODE/SET
Middle 4 digits
MODE/SET
Upper 2 digits
MODE/SET
MODE/SET
Leftmost blinks display shows digit's
position. The digit's display and value
means parameter's value.
Keys
Press the MODE/SET Key to select the monitor mode.
DATA/
Press the UP or DOWN Key to display the parameter to be
displayed in 32-bit decimal.
In this example "Un00D" is selected.
DATA/
Press the DATA/SHIFT Key for approximately one second.
The lower 4 digits of the setting of the selected parameter
are displayed.
DATA/
After checking the displayed digits, press the DATA/SHIFT
Key. The middle 4 digits of the setting of the selected
parameter are displayed.
DATA/
Press the DATA/SHIFT Key again. The upper 2 digits of the
setting of the selected parameter are displayed.
Note: If the DATA/SHIFT Key is pressed after the upper 2
digits are displayed, the lower 4 digits of the setting
DATA/ will be displayed again.
Press the DATA/SHIFT Key for approximately one second
to return to the display of step 2.
DATA/
Middle
four
digits
Displays when negative
number is displayed
31
) and 2147483647 (-2
Operation
Bottom
four digits
31
) is displayed continuously. When