Initializing Parameter Settings (Fn005) - YASKAWA SGMJV User Manual

7 Utility Functions (Fn
7.6

Initializing Parameter Settings (Fn005)

This function is used when returning to the factory settings after changing parameter settings.
Follow the steps below to initialize the parameter setting.
Step
1
2
3
4
5
6
7
8
7-12
)
• Be sure to initialize the parameter settings while the servo ON (/S_ON) signal is OFF
• After initialization, turn OFF the power supply and then turn ON again to validate the
settings.
Display after
Operation
MODE/SET
MODE/SET
MODE/SET
MODE/SET
Display blinks
Display blinks
MODE/SET
Turn OFF the power and then turn ON again to validate the setting.
Keys
Press the MODE/SET Key to select the utility function
mode.
DATA/
Press the UP or DOWN Key to select Fn005.
DATA/
Press the DATA/SHIFT Key for approximately one second.
The display shown on the left appears.
Note: When "no-oP" blinks for approximately one second,
the write prohibited setting is set in Fn010. Change
DATA/
the setting in Fn010, and press the key again after
enabling writing. (Refer to 7.12.)
Press the MODE/SET Key. Then, the parameters will be
initialized.
DATA/
During initialization, the display shown on the left blinks.
When the initialization of parameter setting completes, the
display shown on the left blinks for about one second.
The display changes from "donE" to the display shown on
the left.
Press the DATA/SHIFT Key for approximately one second.
"Fn005" is displayed again.
DATA/
Operation
.