YASKAWA SGMJV User Manual page 76

(2) Changing Output Signal Allocations
Output signals are allocated as shown in the following table.
Refer to the Interpreting the Output Signal Allocation Tables and change the allocations accordingly.
<Interpreting the Output Signal Allocation Tables>
Output Signal Names
and Parameters
Positioning Completion
Pn50E.0
Output Signal Names
and Parameters
Positioning Completion
Pn50E.0
Speed Coincidence
Detection
Pn50E.1
Rotation Detection
Pn50E.2
Servo Ready
Pn50E.3
Torque Limit Detection
Pn50F.0
Speed Limit Detection
Pn50F.1
Brake
Pn50F.2
Warning
Pn50F.3
Near
Pn510.0
Pn512.0=1
Pn512.1=1
Pn512.2=1
• When two or more signals are allocated to the same output circuit, a signal is output
with OR logic circuit.
• The signals not detected are considered as "Invalid." For example, Positioning Com-
pletion (/COIN) signal in speed control is "Invalid."
Output Signal
25 (26)
/COIN 1
Output Signal
25 (26)
/COIN 1
/V-CMP 1
/TGON 1
/S-RDY 1
/CLT 1
/VLT 1
/BK 1
/WARN 1
/NEAR 1
Polarity inversion of CN1-25 (26)
Polarity inversion of CN1-27 (28)
Polarity inversion of CN1-29 (30)
The parameter set values to be used are shown.
Signals are allocated to CN1 pins according to the
selected set values.
Values in cells in bold lines are the factory settings.
CN1 Pin Numbers
27 (28) 29 (30)
2 3
CN1 Pin Numbers
27 (28) 29 (30)
2 3
2 3
2 3
2 3
2 3
2 3
2 3
2 3
2 3
3.3 I/O Signal Allocations
Invalid
not use
0
Invalid
(not use)
0
0
0
0
0
0
0
0
0
0
(Not invert at fac-
tory setting)
3-29
3